Boot (trunk) lid rubber which fits to the boot opening of the vehicle. This rubber is a pinch weld seal that pushes over the metal edge of the boot opening. Please note: The opening edge must be cleaned of any dirt before fitting the pinch weld. Start fitting the pinch weld with the flap of rubber facing out, at the lock striker (middle of the opening) and push on it around the opening until you get near the starting point, carefully cut the rubber and then the pinch weld with a sharp blade approximately 10mm longer and glue the ends together then push the pinch weld back on. Hint: If the vehicle has been repainted you may have to adjust the lock striker in, so the tailgate seals all the way around on the tailgate. On sedans adjust the striker so the boot lid closes level with the ¼ panels. This product suits Holden VB, VC, VH, VK and VL Commodore, L, SL, SL/E, Vacationer, SS, SL/X, Executive, Calais, Berlina, Group A, Formula Sedan Fitted with 4 cylinder Starfire 1.9 Litre, 6 cylinder Red, Blue, Black motor173, 202, Nissan motor, RB20 (New Zealand only), RB30, 8 cylinder 4.2 Litre (253), 5.0 Litre (308) engine.
